■Assembly guide - N700 series typeA Tokaido Shinkansen window mCB tabl

■Assembly guide - N700 series typeA Tokaido Shinkansen window mCB table

*The contents of this page are the same as the instruction manual that comes with your purchase.

① Identify the Parts

First make sure you have all the parts.

A: Window for top board x 1

B: Top plate frame x 1*Assembled

C/C': Legs x 4

D: Reinforcement plate (round plate small size) x 1

E: Shelf board (large round board size) x 1

Parts list "N700 series type A Tokaido Shinkansen window mCB table"

② Preparation for Assembly

Fold all four parts of the legs [C/C'] .

First, fold them to the side without the groove. At that time, slowly lift the edge and gently bend it with a ruler to make a nice bend.

Next, fold them back to the other side (the side with the groove).

Assembly method Step 2 "N700 series type A Tokaido Shinkansen window mCB table"

③ Assembling the Shelf Board and Reinforcing Board

Insert the shelf board and reinforcement version [D/E] into the notches in the legs.

All four legs have the same shape, so you can insert it into any leg. Insert the shelf board and reinforcing board into the two notches at the same time.

If you have trouble inserting it properly, try shaking it gently from front to back and from side to side.

Assembly method Step 3 "N700 series type A Tokaido Shinkansen window mCB table"

④ Assembling the Legs

Insert the remaining legs into the notches in the shelf board and reinforcement version [D/E].

Insert it into the diagonal position of the second leg/first leg.

From the third leg/side, insert it evenly into the four notches.

Just like the 4th/2nd leg, insert it from above.

After fitting the fourth leg, stand it up in the correct direction and check to see if there is any wobble.

If there is any wobbling, one of the legs may not fit properly. In that case, lightly press the back of each leg against the flat floor 2-3 times to make it easier to insert.

Assembly method Step 4 “N700 series type A Tokaido Shinkansen window mCB table”

⑤ Installation of the Top Plate Frame

Align and fit the yellow sticker affixed to the back of the top frame [B] with the leg [C'] that has the yellow sticker with the brand logo affixed to it.

Gently fit it into all 8 places and check the position. If you force it in too much, the top plate frame and the leg inserts may break.

Assembly method Step 5 “N700 series type A Tokaido Shinkansen window mCB table”

⑥ Installation of Window for Top Plate

Finally, place the window for the top board [A] on the top board frame [B] to complete.

Place the leg [C'] with the brand logo on the front right side, and place it on the top frame [B] so that the long sides of the top window are on the left and right. (If there is a logo on the window, please install it so that the logo is in the upper right corner.)

*The window for the top plate is heavy, so please be careful when handling it.

Assembly method Step 6 “N700 series type A Tokaido Shinkansen window mCB table”